VM R750EU6 Manual De Instrucciones página 115

All surfaces and components pro-
tected with "FL MECAFLUID / P118 V"
protective oil can be cleaned with a
suitable solvent.
Check the level of the fluids: engine oil
and coolant. Top up if necessary.
- Engines on vehicles
Check there is no damage to the ex-
ternal engine components; make any
necessary repairs.
Clean the throats of the metal belt pul-
leys, using a suitable solvent. Install
the service belts.
INSTALLATION DESIGN
In order to ensure the highest performan-
ce while protecting people, the product
itself and the environment, a full project
has to be developed before carrying out
the installation.
The design phase should take into
account the technical data of the engine
(see"Technical data") and all the risks whi-
ch may occur during its expected lifetime,
from installation to disposal.
English
R750EU6 - TE4 - IE4 - ISE4
Check the rubber tubes and manifolds
are in good condition, and check the
tightening of the relative fixing clips; if
they are damaged, replace them.
All surfaces and components pro-
tected with "FL MECAFLUID / P118 V"
protective oil can be cleaned with a
suitable solvent.
Check the level of the fluids: engine oil
and coolant. Top up if necessary.
Nothing needs to be done to remove the
internal protection (either for engines on
pallets or on vehicles).
During the design and installation pha-
ses, it is advisable to consult the servi-
ce manual supplied by VM MOTORI.
Further information are available in the
website: www.vmmotori.it, in the "Con-
tacts – Request Info" section.
39
GB
2056G