Publicidad
Maintenance jobs before and during
the frost period
to get a better overview, the maintenance
concerning the aniti freeze will summarized
Time period Work
several times
check brush
daily
daily
check the inside room of
the equipment
check brush shaft
check fuel tank
clean strainer
Clean the filter of the anti
freeze pump.
before the
check the freezing equip-
forst period
ment
Clean the filter of the anti
freeze pump.
monthly or af-
check the anti freeze wa-
ter 160 oper-
ter amount at the anti
ating hours
freeze cycle
Shutdown
If the equipment is to be shut down, and
there is not danger of frost,
disconnect the water input,
disconnect the power supply.
Shutting down by danger of frost
By the option of the base exchanger.
Disconnect the water input between the
base exchanger and the cooler.
Rinse the equipment ( with base ex-
changer (optional)) with anti freeze
agent.
Rinse the base exchanger with a con-
centrat salt agent.
Empty all swimming cointainers, discon-
nect the pipes, and drain offf the water.
Empty the high pessure pump, discon-
nect the pipes from the high pressure
pump, and drain the water.
Disconnect the high pressure pipe at the
head of the pump, and drain the water.
Store the cleaning agent container and
the fuel container at a non-freezen
place.
If not surtain when shutting down, please
call your local service.
30
here. The checking of the anti freeze must
be done yearly before the frost perod. In
section " maintenance and service" ought
to be performed also in the winter time.
Performance
check for dirt and ice, that's to mean lock brush washing
is the heating fan operating?
Is the drain to the swimming container free of ice?
Checl fill-in tank, that's to mean fill.
Open the screw ( one top of the high-pressure pump), take out the strainer and
clean it, put the strainer back in, close the screws tight.
Clean the strainer and put it back in
Change the freezing themerature in the direction of "check", until the anti freeze
equipment is turned on. Fan heater and freezing cycle must start. If the temper-
ature is above 5 °C in addition, turn the thermostat of the fan heater up. After-
wards turn the anti freezing thermostat all way against the clock back. Turn the
thermostat of the fan heater back.
Notice
The openings in the equipment socket may not be closed, otherwise the func-
tion of the anti freeze thermostat is interrupted.
Clean the filter and put it back in
set value: approximately 0,5l/min, lager water amount: change the joint part in
the hand blowing gun. smaller water amount: Clean the strainer of the anti
freeze water and the filter of the anti freeze pump, check the direction of the
pump.
EN
Notice
Maintenance not being done on time or
from experts will mean, that there is no
guarantee concerning frost damage.
7
-
by whom
operator
operator
operator
operator
operator
operator
Publicidad
