Publicidad
1 Control box
2 Display control circuit board
3 Fuel filter and fuel pump
4 Burner fan
5 Burner inclusive flow-type heater
6 Photocell, flame indicator
7 High pressure pump
8 Anti freeze thermostat
9 Operating panel
10 Container for softener (RM 110, optional)
11 Control head (optional)
12 Swimming container fresh water
13 Base exchanger (optional)
14 Fan heater
15 Strainer
16 Salt tank (optional)
17 Seal
18 Swimming container anti freeze
19 Centrifugal pump
20 Filter anti freeze pump
21 Strainer
22 Bolting
Maintenance and care
System overview
Maintenance instructions
The bases of a safe operating of the equip-
ment is thr regularly maintenance accord-
ing to the following maintenance plan.
Use only original parts of the manufacturer
or part suggessted by him, such as
parts and wearing parts,
–
accessories parts,
–
operating materials,
–
cleaning agents.
–
Danger!
There is danger of injury while working at
the equipment.. Concerning all works
disconnect the input water, close the
water supply,
disconnect the power supply, shut off
the customer emergency main switch,
and secure, that it can not be turned on.
Notice
If the main power supply is interrupted
(main power supply interruption, customer
emergency off main switch is put to „0") the
clock in the control head of the base ex-
changer will stop and must be readjusted.
10
-
EN
Who may perform maintenance?
operator
–
Performances containing the notice
"operator" may only be performed by in-
structed individualls, who are able to
operate and service high pressure
equipment.
Maintenance
–
Performances with the notice "mainte-
nance" may only be performed by the
Kärcher- Maintenance-Mechanics.
Maintenance contract
In order to guarantee a reliable operation
og the equipment, we success, you signed
a maintenance agreement. Please refer to
you local Kärcher service department.
Danger!
danger of injury because of possible dam-
aged parts of the high pressure jet, danger of
burns because of hot equipment parts..
When working, while the equipment is open
take special care, and obey all safty notices!.
The following parts are possible to be hot-
ter than 50 °C:
exhaust pipe and exhaust opening
–
Burner inclusive flow-type heater
–
cylinder head of the high pressure
–
pump
high pressure hose
–
33
Publicidad
