Dell EMC PowerEdge T130 Manual Del Propietário página 108

NOTE: This is a Field Replaceable Unit (FRU). Removal and installation procedures must be performed only by Dell certified
service technicians.
CAUTION: Do not lift the system board by holding a memory module, processor, or other components.
CAUTION: Take care not to damage the system identification button while placing the system board into the chassis.
1 Follow the safety guidelines listed in Safety instructions section.
2 Follow the procedure listed in the Before working inside your system section.
3 Keep the Phillips #2 screwdriver ready.
Steps
1 Hold the system board by its edges, and orient it toward the back of the chassis.
2 Lower the system board into the chassis until the connectors at the back of the system board align with the slots on the back of the
chassis.
3 Tighten the screws that secure the system board to the chassis.
Figure 58. Install the system board
1 touch point (2)
3 system board t-handle post
Next steps
1 If required, install the Trusted Platform Module (TPM). See, the Installing the Trusted Platform Module section.
108 Instalación y extracción de los componentes del sistema
2 system board