Dell EMC PowerEdge T130 Manual Del Propietário página 121

Paso siguiente
If the problem persists, see the Getting help section.
Troubleshooting the sistema battery
Requisitos previos
PRECAUCIÓN: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
NOTA: If the sistema is turned off for long periods of time (for weeks or months), the NVRAM may lose the sistema
configuration information. This situation is caused by a defective battery.
NOTA: Some software may cause the sistema time to speed up or slow down. If the sistema seems to operate normally except
for the time set in System Setup, the problem may be caused by a software, rather than by a defective battery.
Pasos
1 Re-enter the time and date in System Setup.
2 Turn off the sistema, and disconnect it from the electrical outlet for at least an hour.
3 Reconnect the sistema to the electrical outlet, and turn on the sistema.
4 Enter System Setup.
If the date and time displayed in System Setup are not correct, check the System Error Log (SEL) for sistema battery messages.
Paso siguiente
If the problem persists, see the Getting help section.
Troubleshooting power supply units
PRECAUCIÓN: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and
simple repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
The following sections provide information on troubleshooting power source and power supply units problems.
Solución de problemas de fuente de alimentación
1 Presione el botón de encendido para asegurarse de que el sistema esté encendido. Si el indicador de alimentación no se enciende
cuando se presiona el botón de encendido, presione el botón de encendido con firmeza.
2 Conecte otra fuente de alimentación en buenas condiciones para asegurarse de que la placa base no sea defectuosa.
3 Asegúrese de que no existan conexiones sueltas.
Por ejemplo, con los cables de alimentación.
4 Asegúrese de que la fuente de alimentación cumple con los estándares correspondientes.
5 Asegúrese de que no existan corto circuitos.
6 Solicite que un electricista cualificado compruebe el voltaje de línea para asegurarse de que cumple las especificaciones necesarias.
Problemas de la unidad de fuente de alimentación
1 Asegúrese de que no existan conexiones sueltas.
Por ejemplo, con los cables de alimentación.
2 Asegúrese de que el LED/asa de la fuente de alimentación indica que la fuente de alimentación funciona correctamente.
Troubleshooting your sistema 121