Dell EMC PowerEdge T130 Manual Del Propietário página 93

3 Keep the Phillips #2 screwdriver ready.
Steps
1 Align and insert the tabs on the iDRAC port card into the slots on the chassis.
2 Insert the iDRAC port card into the connector on the system board.
3 Tighten the screw that secures the iDRAC port card holder to the system board.
Figure 45. Installing the iDRAC port card
1 iDRAC port
3 iDRAC port card connector
5 screw
Next steps
1 If disconnected, reconnect the network cable.
2 Follow the procedure listed in the After working inside your system section.
Procesadores y disipadores de calor
Siga el siguiente procedimiento cuando:
• Extracción e instalación de un disipador de calor
• Instale un procesador adicional
• Reemplace un procesador
2 SD vFlash media card slot
4 iDRAC port card board
Instalación y extracción de los componentes del sistema 93