Dell EMC PowerEdge T130 Manual Del Propietário página 76

1 Ensure that you follow the
2 Follow the procedure listed in
3 Disconnect all peripherals connected to the I/O module.
4 Remove the bezel.
5 If connected, disconnect the power and data cables from the optical drive and hard drives.
6 Remove the hard drive cage.
7 If installed, remove the optical drive blank from the bezel and the optical drive filler from the hard drive cage.
Steps
1 Align the optical drive with the optical drive slot on the front of the chassis.
2 Slide the optical drive into the slot until the release tab locks into place.
3 Connect the power and data cables to the optical drive.
4 Route the power and data cables through the cable routing guides on the system chassis.
Figure 32. Installing the optical drive
1 SATA and power cable
3 optical drive
Next steps
1 Install the hard drive cage.
2 If disconnected, reconnect the disconnected data and power cables to the hard drives and optical drive.
3 Install the bezel.
4 Reconnect the peripherals disconnected from the control panel assembly.
5 Follow the procedure listed in
76 Instalación y extracción de los componentes del sistema
Instrucciones de seguridad.
Antes de trabajar en el interior de su
Después de trabajar en el interior de su
equipo.
2 release tab
4 hard drive cage
equipo.