Dell EMC PowerEdge T130 Manual Del Propietário página 88

Next steps
1 Install an expansion card.
2 Follow the procedure listed in
Related links
Installing an expansion card
Installing an expansion card
Prerequisites
CAUTION: Many repairs may only be done by a certified service technician. You should only perform troubleshooting and simple
repairs as authorized in your product documentation, or as directed by the online or telephone service and support team.
Damage due to servicing that is not authorized by Dell is not covered by your warranty. Read and follow the safety instructions
that are shipped with your product.
1 Ensure that you follow the
2 Follow the procedure listed in
Steps
1 Unpack the expansion card and prepare it for installation.
For instructions, see the documentation accompanying the card.
2 Press and push out the expansion card release latch to open it.
3 Remove the expansion card blank if you are installing a new expansion card.
The steps for installing or removing an expansion card blank are similar to installing or removing an expansion card.
NOTE: Keep the expansion card blank for future use. Expansion card blank must be installed into empty expansion card slots
to maintain FCC certification of the system. The blanks also keep dust and dirt out of the system and aid in proper cooling
and airflow inside the system.
4 Holding the expansion card by its edges, position the card so that the card-edge connector aligns with the expansion card connector.
5 Push the expansion card into the expansion card slot until the expansion card is fully seated.
6 Press the expansion card latch down toward the system until it clicks into place.
88 Instalación y extracción de los componentes del sistema
Después de manipular el interior del
Instrucciones de seguridad.
Antes de manipular el interior del
sistema.
sistema.