Publicidad
61
Hinweise zur elektromagneti-
schen Verträglichkeit (EMV)
Guidelines and manufacturer's declaration – electromagnetic interference immunity for medical electrical devices that are not life-supporting
The TELE PACK VET X model 69 0450 20 is designed for operation in the electromagnetic environment defined below.
The user of the TELE PACK VET X model 69 0450 20 should ensure that it is used in such an environment.
Interference immunity
EN/IEC 60601
tests
test level
Conducted RF
3 Vrms
disturbance acc. to
150 kHz to < 80 MHz
IEC 61000-4-6
3 V/m
Radiated RF disturbance
acc. to IEC 61000-4-3
80 MHz to 2.5 GHz
Note: These guidelines may not apply in all situations. The propagation of electromagnetic quantities is affected by absorptions and reflections of buildings,
objects, and persons.
a The field strength of stationary transmitters, such as base stations of radio phones and land mobile radio services, CB radio stations, AM and FM radio,
and TV stations cannot be exactly predetermined by theory. For the determination of the electromagnetic environment of the stationary transmitters, a site
survey should be considered. If the measured field strength in the location at which the device is used exceeds the above conformity levels, the device
should be observed to verify normal operation. If unusual performance characteristics are observed, additional measures may be necessary, such as a modi-
fied alignment or a different location for the device.
b Above the frequency range 150 kHz to 80 MHz, field strength should be less than 3 V/m.
Nur für den Veterinärgebrauch
Electromagnetic compatibility
(EMC) information
Table 204
Conformity level
Portable and mobile RF communications equipment should be used
no closer to any part of the TELE PACK VET X model 69 0450 20,
including cables, than the recommended separation distance calcu-
lated from the equation applicable to the frequency of the transmitter.
Recommended separation distance:
[
d
=
3
5 ,
3 Vrms
[
d
=
3
5 ,
3 V/m
[ ]
d
=
7
3 /
Where P is the nominal power of the transmitter in Watt [W] according
to the information provided by the manufacturer of the transmitter and
d is the recommended separation distance in meters [m].
The field strength of stationary transmitters at all frequencies on site a
should be, according to a study, less than the conformity level. b
Interferences may occur in the vicinity of devices that carry the follow-
ing symbol:
For veterinary use only
indicaciones sobre compatibi-
lidad electromagnética (CEM)
Electromagnetic environment – guidelines
]
3 /
P
150 kHz to < 80 MHz
]
3 /
P
80 MHz to < 800 MHz
P
800 MHz to 2.5 GHz
Sólo para uso veterinario
Publicidad
