Publicidad
34
POWER
MENU
RETURN
5
TUNING/SELECT
ST-S361
POWER
~
MENU
RETURN
5
TUNING/SELECT
a
BESS
oo
O-
ST-S261
ENTER
Preset Tuning
(continued)
The following settings will be stored along
with the station
ST-S361: ANT (A or B), ANT ATT, IF Band
and FM MODE
ST-S261: FM MODE
if you perform the scanning
again
Some of the preset stations may be replaced
with new ones depending on the reception
quality.
To cancel the scanning
Perform one of the following procedures.
¢ Press RETURN. The scanning stops and
the display returns to the "Auto-betical"
menu.
If you press RETURN again, the display
shows the currently received frequency.
* Press ENTER. The scanning stops and
the display shows the currently received
frequency.
To tune in stored stations
See page 40.
To erase stored stations one by
one
1 Press MENU.
2 Rotate the TUNING/SELECT knob until
"Clear" appears and then press ENTER.
3 Rotate the TUNING/SELECT knob until
the preset station to be erased appears
and then press ENTER.
The frequency stored in the specified
code is erased and the digit ofthe preset
code disappears.
4 Repeat steps 1 through 3 for other stored
stations to be erased.
To erase all stored stations at a
time
1 Turn off the power.
2 Hold down 5 and MENU, and press
POWER to turn on the poweragain.
Notes
* If you move to another area, do this
procedure again to store the siations for
the new broadcast area.
* If you move the antenna afterstoring
stations using "Auto-betical" »x "AUTO-
BET", the stored settings will mo longer
be valid. If this happens, store the
stations again.
Publicidad
