Kärcher B300 RI BP Manual Del Usuario página 42

Clean the vehicle daily after finishing work.
CAUTION
Risk of injury!
Wear a dust mask and safety goggles.
ATTENTION
Risk of damage!
Exercise caution when cleaning with the high-pressure cleaner!
Radiator fins, hydraulic hoses and valves, seals, electrical and
electronic components must not be cleaned using a high-pres-
sure cleaner.
Observe the applicable safety instructions when cleaning the ve-
hicle with a high-pressure cleaner.
Do not use aggressive cleaning agents.
Clean the unit using a damp cloth, wetted with a mild washing lye.
Cleaning the fresh water tank
Fresh water tank
1
Fresh water tank cap
2
Filling level display
3
Fresh water drain hose
4
1. Flush the fresh water tank with fresh water after finishing work.
2. Drain residual water using the drain hose.
Cleaning the sealing lips, suction bar and spray nozzles
Suction bar
1
Suction hose
2
Sealing strip
3
1. Clean the suction bar and suction hose.
2. Clean the side sealing strips.
3. Clean the spray nozzles on the side scrubbing deck and roller
brush.
42
Cleaning Cleaning the waste container
Waste container
1
Waste container flap
2
Safety bracket
3
WARNING
Risk of injury and damage!
Always use and secure the safety support when the tilting device
is raised.
Do not use a high-pressure cleaner or water stream for cleaning
(dust filter cartridges)!
1. Clean the inside of the waste container with compressed air
and a brush.
2. In case of stubborn dirt: Clean the inside of the waste contain-
er with water and a brush, allow the open waste container to
dry out.
Water filter
1
Water filter housing
2
Stop cock (open position)
3
1. Close the stop cock.
2. Unscrew the water filter casing.
3. Remove the water filter insert and clean or replace it.
4. Open the stop cock again after installation.
English
Cleaning the water filter