Publicidad
Idiomas disponibles
Idiomas disponibles
Malfunction
Vehicle does not start
Vehicle moves only slowly or not at
all
Waste container does not rise or
lower
High wear and tear of the brushes Reduce the brush contact pressure.
Brushes do not turn or only slowly Check the hydraulic oil level.
Wet cleaning: Cleaning results are
unsatisfactory
Wet cleaning: Cleaning fluid on
cleaning surface
Wet cleaning: No cleaning fluid
Sweeping: Insufficient cleaning re-
sults
Sweeping: Dust and dirt comes out
of the waste container
Brush or suction bar does not low-
er/raise
Malfunctions that are not displayed
Rectification
Sit in the driver's seat.
Charge the battery, check, replace if necessary.
Replace the faulty fuses.
Contact an authorised Customer Service department
Release the parking brake
Contact an authorised Customer Service department
Check the hydraulic oil level.
Checking whether the flap of the waste container is closed
Open the stop cock on the hydraulic filter or replace the clogged hydraulic filter
Waste container is too full/heavy
Contact an authorised Customer Service department
The cleaning surface is too abrasive, use other brushes if necessary.
Switch on the suction fan.
Removing cords and straps
Contact an authorised Customer Service department
Increase the brush contact pressure.
Reduce the working speed.
Fill up the fresh water tank.
Checking the water dosing
Removing cords and straps
Brushes are worn, replace
Cleaning/adjusting/replacing the squeegee blade
Cleaning the suction channel
Replacing the worn suction bar seals
Switch on the suction fan.
Empty the waste water tank, suction turbine was switched off by signalling device
Cleaning the suction bar
Cleaning/adjusting/replacing the squeegee blade
Cleaning the suction channel
Cleaning/replacing the contaminated flat fold filter
Adjusting the suction bar correctly
Cleaning the lines and spray nozzles
Fill up the fresh water tank.
Switch on the water pump
Opening the water dosing
Clean the water filter.
Increase the brush contact pressure.
Emptying the full waste container
Opening the waste container flap
Reduce the working speed.
Brushes are worn, replace
Clean the dirty dust filter with the filter cleaner.
Dust filter is dirty or defective, clean or replace
Removing cords and straps
Cleaning/adjusting/replacing the squeegee blade
Contact an authorised Customer Service department
Emptying the full waste container
Switch on the suction fan.
Closing the waste container flap
Replace the defective seal from the flap of the waste container
Contact an authorised Customer Service department
English
45
Publicidad
