Franklin Electric E-Tech VSI Manual De Uso E Instalación página 11

Use and installation instruction manual
1.2 Deposit and Storage
The pump must be stored at a temperature between -20°C and +60°C and must
not be exposed to sunlight. If the machine has not been packed, it must be stored
in the warehouse horizontally, adequately supported, or vertically, to prevent
possible misalignment. During storage, the machine can be supported as shown
in Fig. 1.
Drain the machine completely
extended period of time.
dry, protected from the
Consult the engine manual for additional information regarding its storage.
Pump identification code (Fig. 3)
VSI 184 / 04 I / 2B
2.1 Pump rating plate
To properly read the rating plate, refer to the following instructions (Fig. 4). Please note that the information provided on the rating plate may be arranged differently
from what is shown below. Refer to the symbols describing the reference fields. Some information may not be available, depending on the model considered.
A
B C
E
D
m3/h m
G H
m
m
I L
N O
Fig. 4
before storing it
The storage environment
possible formation of dirt
- W R - M8 - 50 D
A) Pump identification code
B) Product code
C) Serial number
D) Operating flow range
E) Operating head range
F
F) Maximum mechanical power absorbed by the pump with rewindable motor
kW
G) Minimum head
H) Maximum head
M
I) Maximum operating pressure [Mpa]
P
L) Maximum operating pressure [bar]
M) Nominal rotation speed with rewindable motor
Made in Italy
N) Pump weight
O) Maximum temperature of the pumped liquid (excluding industrial uses see below)
P) Year of production
2 PRODUCT INFORMATION
The data plate indicates the model, main service specifications and serial number.
It is important to provide such information when requesting intervention or
assistance and when requesting spare parts. For the location of the data plate,
see Fig. 2.
The machine model is identified by the alphanumeric identification code shown
for an
on the data plate. The meaning of the characters making up the code is shown in
must be
Fig. 3. In addition to the identification code, the product is identified by the serial
and rust.
number (Fig. 4). This information is also shown on the additional plate attached
to this manual.
L E - A
Special configuration; "Empty" (not special configuration)
Rubber parts material: "E" (EPDM)
Cable guard type: "L" (Low), "M" (Medium), "H" (High)
DOL or Star/Delta: "D" DOL (1 cable guard), "S" Start/Delta (2 cable
guards)
Frequency: ''50'' (50 Hz), ''60'' (60 Hz)
Motor bracket dimension: "M6" (6"), "M8" (8"), "M10" (10"), "M12" (12")
Type of threaded connection: "R" (Rp), "N" (NPT)
Check valve: "W" (Pump with check valve)
Impellers configuration
Material: ''I'' (CF8/304), ''N'' (CF8M/316), ''R'' (DUPLEX)
Total number of stages
Flow [m³/h] / Model
Pump model
ENGLISH
9