Calibration (Cal Menu) - Xylem SI Analytics TitroLine 6000 Manual De Instrucciones

113
®
Chapter 3 – Working with the titrator TitroLine 6000/7000
The consumption in ml will be displayed on the X axis, the Y axis will show the measurement reading. Scaling of
the chart will be done automatically. The result will be displayed at the end of the titration (Fig. 35).
Fig. 35
<MODE>/<F6> can be used to view the titration curve or further resuts. pH und mV titration curves will show the
st
measurement curve (blue) and the 1 derivation (red). The values and the location of the equivalence point are
identified directly in the curve itself.
Fig. 36
If a printer is connected, the results will either be printed according to the settings made for the method, or else
they will be memorised in the form of a PDF- and CSV-file file on a connected USB stick. If no printer or USB
stick is connected, the bottom left corner of the display will show the message "no printer" or "no USB
stick".<ESC> will take you back to the main menu where you can start the next titration immediately.
3.6.2

Calibration (CAL menu)

If you are on the main menu (Fig. 37), calibration is started by pressing the <CAL> key on the titrator or the
<F8/CAL> key.
Fig. 37