YASKAWA CIPR-GA50C Serie Manual De Instrucciones página 19

Sym
Name
bol
RUN LED
G
Left Arrow Key
Up Arrow Key/
Down Arrow Key
/
H
Right Arrow Key
(RESET)
ENTER Key
ESC Key
I
J LED Display
YASKAWA TOMPC7106173UA GA500 Installation and Operation Instruction
Illuminated: The drive is in normal operation.
OFF: The drive is stopped.
Flashing:
• The drive is decelerating to stop.
• The drive received a Run command with a frequency reference of 0 Hz, but the
drive is not set for zero speed control
Flashing quickly:
• The drive received a Run command from the MFDI terminals while in LOCAL
Mode and it switched to REMOTE Mode.
• The drive received a Run command from the MFDI terminals when the drive is
not in Drive Mode.
• The drive received a Fast Stop command.
• The safety function shut off the drive output.
• You pushed
on the keypad while the drive is operating in REMOTE
Mode.
• The drive is energized with an active Run command and b1-17 = 0 [Run
Command at Power Up = Disregard Existing RUN Command].
Moves the cursor to the left.
• Moves to a different screen.
• Selects parameter numbers and increments or decrements setting values.
• Moves the cursor to the right.
• Resets the drive to clear a fault.
• Enters parameter values and settings.
• Selects each mode, parameter, and set value.
• Goes back to the previous screen.
• Push and hold to go back to the frequency reference screen (the initial screen).
Shows parameters, errors, and other data.
Function
1 English
19