YASKAWA CIPR-GA50C Serie Manual De Instrucciones página 350

10 Attachment
10 Attachment
◆
UL Standards
The UL/cUL Mark identifies that this product conforms to rigid safety standards. This
mark appears on products in the United States and Canada. It shows UL approval, which
identifies that the product complies with safety standards after careful inspection and
assessment. You must use UL Listed or UL Recognized parts for all primary components
that are built into electrical equipment that has UL approval.
This product has been tested in accordance with UL standard UL61800-5-1, and has been
verified to be in compliance with UL standards.
Machines and devices integrated with this product must satisfy the following conditions
for compliance with UL standards:
■
Area of Use
Install this product in a location with Overvoltage Category III and pollution degree 2 or
less as specified in UL61800-5-1.
Ambient Temperature Setting
Maintain the ambient temperature within the following ranges according to the enclosure
type.
• IP20/UL Type 1: -10 °C to +40 °C (14 °F to 104 °F)
• IP20/UL Open Type: -10 °C to +50 °C (14 °F to 122 °F)
■
Wire the Main Circuit Terminal Block
Wire the main circuit terminal block correctly as specified by the instructions in the
manual.
To select the correct wire gauge, refer to
Torques on page 350.
Main Circuit Wire Gauges and Tightening Torques
Refer to Single-Phase 200 V Class on page
and Three-Phase 400 V Class on page 391
tightening torques of the main circuit terminals.
350
Figure 10.1 UL/cUL Mark
Main Circuit Wire Gauges and Tightening
383, Three-Phase 200 V Class on page
for the recommended wire gauges and
YASKAWA TOMPC7106173UA GA500 Installation and Operation Instruction
386,