YASKAWA CIPR-GA50C Serie Manual De Instrucciones página 28

1 English
User Parameter
A2-13
A2-14
A2-15
A2-16
A2-17
A2-18
A2-19
A2-20
A2-21
A2-22
A2-23
A2-24
A2-25
A2-26
Note:
• When you change A1-02 [Control Mode Selection], the settings of some parameters automatically change.
• This manual also shows parameters that are not in Setup Mode. Use
parameters not shown in the Setup Mode.
• Display parameters change when the A1-06 [Application Preset] setting changes.
◆
Drive Parameters
Refer to the following table when you set the most important parameters.
Note:
You can change parameters that have "RUN" in the "No." column during drive operation.
28
Parameter
d1-17
E1-01
E1-03
E1-04
E1-05
E1-06
E1-09
E1-13
E2-01
E2-04
E2-11
H4-02
L1-01
L3-04
YASKAWA TOMPC7106173UA GA500 Installation and Operation Instruction
Name
Jog Reference
Input AC Supply Voltage
V/f Pattern Selection
Maximum Output Frequency
Maximum Output Voltage
Base Frequency
Minimum Output Frequency
Base Voltage
Motor Rated Current (FLA)
Motor Pole Count
Motor Rated Power
Terminal AM Analog Output Gain
Motor Overload (oL1) Protection
Stall Prevention during Decel
menu to set the