YASKAWA CIPR-GA50C Serie Manual De Instrucciones página 352
Ocultar thumbs
Ver también para CIPR-GA50C Serie:
- Instrucciones de instalación y operación (310 páginas)
Publicidad
Idiomas disponibles
Idiomas disponibles
10 Attachment
• Wire gauges on the drive you are replacing may not match the wire gauge ranges on
your new drive. Refer to the drive manuals for correct wire sizes.
• Do not tighten the terminal screws at an angle of 5 degrees or more. Failure to obey can
cause damage to the terminal screws.
If you damage a terminal screw, contact Yaskawa or your nearest sales representative.
• Put the bit all the way into the hex socket to tighten the hex socket cap screw.
• When you tighten slotted screws, hold the straight-edge screwdriver perpendicularly to
the screw. Make sure that you align the end of the straight-edge screwdriver with the
screw groove.
• After you connect the wires to the terminal block, lightly pull on the wires to make sure
that they do not come out of the terminals.
• Do not let strain on the wiring cause damage. Use a strain relief near the wiring to
release the tension. Refer to
352
Figure 10.2 Permitted Angle
Figure 10.3 Tightening Slotted Screws
Figure 10.4
for an example.
YASKAWA TOMPC7106173UA GA500 Installation and Operation Instruction
Publicidad
