YASKAWA CIPR-GA50C Serie Manual De Instrucciones página 45

5.
Connect an AC reactor or DC reactor to decrease harmonic distortion.
Note:
To comply with EN 61000-3-2 on drive models 2001 to 2006, 4001 to 4004, install a DC reactor. Refer
to Table 1.9 to select the correct DC reactor.
Drive Model
2001 - 2006
4001 - 4004
■
Enable the Internal EMC Filter
On drive models BxxxE, 2xxxE, and 4xxxE, move the screw or screws to turn ON and
OFF (enable and disable) the EMC filter.
Make sure that the symmetric grounding network is applied, and install the screw or
screws in the ON position to enable the built-in EMC filter in compliance with the EMC
Directive. The EMC filter switch screw or screws are installed in the OFF position by
default.
WARNING
specified on the warning label, and check the drive for dangerous voltages before you remove covers or
touch EMC filter screws. If you touch the screws when there are dangerous voltages, it will cause serious
injury or death.
WARNING
drive is energized. If you touch the internal components of an energized drive, it can cause serious injury
or death.
WARNING
models BxxxE, 2xxxE, and 4xxxE to comply with the EMC Directive before you turn on the EMC filter or if
there is high resistance grounding. If you turn ON the EMC filter, but you do not ground the neutral point, it
can cause serious injury or death.
WARNING
equipment that is not grounded, it can cause serious injury or death.
NOTICE
tighten to the specified torque. If you fully remove the screws or tighten the screws to an incorrect torque,
it can cause drive failure.
NOTICE
not symmetrically grounded. If the screws are not in the correct position, it can cause damage to the drive.
YASKAWA TOMPC7106173UA GA500 Installation and Operation Instruction
Table 1.9 DC Reactors for Harmonic Suppression
Electrical Shock Hazard. Disconnect all power to the drive, wait for the time
Electrical Shock Hazard. Do not remove covers or touch circuit boards while the
Electrical Shock Hazard. Ground the neutral point on the power supply of drive
Electrical Shock Hazard. Connect the ground cable correctly. If you touch electrical
To disable the internal EMC filter, move the screws from ON to OFF and then
Move the EMC switch screw or screws to the OFF position for networks that are
DC reactor
Manufacturer: Yaskawa
Model
UZDA-B
UZDA-B
1 English
Rating
5.4 A, 8 mH
3.2 A, 28 mH
45