Main Operational Components Of The Machine; Central Unit; Radio Communication Sensors; Set Back - SICE A 948 Manual De Instrucciones

Steering angle toe difference on the front wheels. The angle is conventionally measured with
the wheel on the inside of the curve turned through 20°.
The unit of measurement is degrees.
6) SET BACK (or misalignment of wheels on the same axle) (fig. 41)
This measurement shows the difference in position of one wheel with respect to the other on the
perpendicular of the longitudinal axis of the vehicle.
Set back is measured on the front and rear axles of the vehicle; although rear set-back must not
be confused with the thrust angle.
The unit of measurement is degrees.
7) THRUST ANGLE (fig. 42)
This is the angle formed between the axis of symmetry of the vehicle and the direction of travel
of the rear axle.
The unit of measurement is degrees.

MAIN OPERATIONAL COMPONENTS OF THE MACHINE

WARNING
Get to know your machine. The best way to prevent accidents and obtain top performance
from the machine is to ensure that all operators know how the machine works.
Learn the function and location of all commands.
Carefully check that all the commands on the machine are working properly.
To avoid accidents and injury, the machine must be installed properly, operated correctly
and serviced regularly.

Central Unit

Fig. 22
1 - Master switch
2 - Keyboard
3 - LCDmonitor
4 - Mouse
5 - Turntables
6 - Personal computer
7 - Colour INK-JET printer
8 - Charging contacts
9 - Charging supports
10 - Charging LED
11- Hard Lock

Radio communication sensors

The sensors (fig. 24) of this aligner do not require any cables or cords because they have been
designed using the latest CCD technology.
The angles are measured by means of 8 CCD goniometers and the data are transmitted from
the sensors to the central unit by means of radio-frequency devices.
16