Information Regarding Machine Demolition; Environmental Information - SICE S 63 Manual De Instrucciones

damage that would affect centring accuracy.
After use, store cones and flanges in a place
where they are suitably protected from
dust and dirt.
If necessary, use ethyl alcohol to clean the
display panel.
Perform the calibration procedure at least
once every six months.
INFORMATION
REGARDING
MACHINE
DEMOLITION
If the machine is to be scrapped, remove all
electrical, electronic, plastic and metal parts
and dispose of them separately in accord-
ance with current provisions as prescribed
by law.
ENVIRONMENTAL
INFORMATION
The disposal procedure described below
only applies to machines with the symbol
of the waste bin with a bar across it
on their data plates.
This product may contain substances that
can be hazardous to the environment and
to human health if it is not disposed of
properly.
The following information is therefore pro-
vided to prevent the release of these sub-
stances and to improve the use of natural
resources.
Electrical and electronic equipment must
never be disposed of in the usual municipal
waste but must be separately collected for
their proper treatment.
The crossed-out bin symbol, placed on
74
the product and on this page, reminds the
user that the product must be disposed of
properly at the end of its life.
In this way it is possible to prevent that a
non specific treatment of the substances
contained in these products, or their
improper use, or improper use of their
parts may be hazardous to the environment
or to human health. Furthermore, this helps
to recover, recycle and reuse many of the
materials contained in these products.
Electrical and electronic manufacturers and
distributors set up proper collection and
treatment systems for these products for
this purpose.
Contact your local distributor to obtain
information on the collection procedures
at the end of the life of your product.
When purchasing this product, your dis-
tributor will also inform you of the possibil-
ity to return another end-of-life piece of
equipment free of charge as long as it is of
equivalent type and had the same functions
as the purchased product.
Any disposal of the product performed in
a different way from that described above
will be liable to the penalties provided for
by the national regulations in force in the
country where the product is disposed of.
Further measures for environmental pro-
tection are recommended: recycling of
the internal and external packaging of the
product and proper disposal of used bat-
teries (only if contained in the product).
Your help is crucial in reducing the amount
of natural resources used for manufactur-
ing electrical and electronic equipment,
minimise the use of landfills for product dis-
posal and improve the quality of life, pre-
venting potentially hazardous substances
from being released in the environment.
User manual S 63