SICE S 63 Manual De Instrucciones página 45

WARNING
Adjust the height of the feet on the machi-
ne support platform so that the machine
is stably positioned on the ground. Then
block the feet in this position, tightening
the checknut.
User manual S 63
Fixing the machine to the
N.B.: It is NOT mandatory to fasten the
wheel balancer to the ground.
If you wish to do so, proceed as follows:
4
- Remove the two brackets by unscrewing
the two M8x60 hex head screws fixing the
machine to the pallet; These brackets are
used to fix the machine to the ground;
- Position the machine on the ground in
the selected position and make sure that
the surrounding spaces correspond to the
minimum values indicated in Fig. 5a;
4a
600
- Trace the position for drilling on the floor;
- Drill in the traced position and then take
the included Fischer M8 and insert them
into the holes that were made;
- Collect the two M8x60 hex head screws,
the two washers and the two brackets that
fastened the machine to the pallet;
ground (Fig. 5)
1000
5
1000
5a
45