Faults - What To Do - Gaggenau CI 292 600 Manual De Instrucciones

Faults – what to do?
Generally, faults are easy to remedy. Please read the
notes in the table before calling Customer Service.
Display screen
None
An audible signal sounds. The control panel is damp or an object is
"ƒ "‰ƒ‹ˆ
/
"... "‰ƒ‹‰
/
"†
+ heat setting and
audible signal
"†
and audible signal
"‚ "‡
/
"‰
"Š
"‰ƒ‹ƒ
"‰ƒ‹„
"‰ƒ‹...
"‰ƒ‹†
"‰ƒ‹‡
The temperature sensor
display does not light up.
The indicator on the tem-
perature sensor flashes
twice.
Do not place hot pans on the control panel.
44
Possible cause
The power supply has been disconnected. Use other electrical devices to check whether a short-cir-
The device has not been connected
according to the circuit diagram.
Electronic fault.
covering it.
The electronics have overheated and
switched off the corresponding burner.
The electronics have overheated and have
switched off all burners.
A hot pot is in the area of the control panel.
There is a risk that the electronics will over-
heat.
A hot pot is in the area of the control panel.
To protect the electronics, the burner has
been switched off.
The burner has overheated and switched
itself off to protect the work surface.
The burner was operating for an extended
period without interruption.
The flex function cannot be activated.
The temperature sensor is overheated and
the burner was switched off.
The temperature sensor is overheated and
all burners were switched off.
The battery in the temperature sensor is
dead.
The temperature sensor is no longer con-
nected.
The temperature sensor is broken/defec-
tive.
The temperature sensor does not react
and the display does not light up.
The battery in the temperature sensor has
almost run out. You may be interrupted the
next time you cook by the battery running
out.
Troubleshooting
cuit has occurred in the power supply.
Ensure that the device has been connected according to
the circuit diagram.
If the fault cannot be eliminated, inform the technical after-
sales service.
Dry the control panel or remove the object.
Wait until the electronics have cooled down sufficiently.
Then touch any symbol on the cooktop.
Remove the pot. The fault display goes out shortly after-
wards. You can continue to cook.
Remove the pot. Wait a few seconds. Touch any control.
When the fault indicator goes out, you can continue to
cook.
Wait until the electronics have cooled down sufficiently
and switch the burner on again.
The automatic safety switch-off function has been acti-
vated. See section ~ "Automatic shut-off"
Check the fault display, to do this, touch any control. You
can continue cooking as usual with the remaining burn-
ers. Contact the technical after-sales service.
Wait until the temperature sensor has cooled off suffi-
ciently before activating the function again.
If the temperature sensor is not being used, remove it
from the cookware and keep it far away from other burn-
ers and heat sources. Switch the burners on again.
Change the battery 3V CR2032. See section "Changing
the battery."
Switch the function off and then on again.
Contact the technical after-sales service.
Change the battery 3V CR2032. See section "Changing
the battery."
If this does not solve the problem, press and hold the
symbol on the temperature sensor for 8 seconds and then
reconnect the temperature sensor to the cooktop.
If the problem still persists, contact the technical after-
sales service.
Change the 3V CR2032 battery. See section "Changing
the battery."