Getting Started - Up To 100 Inverters Via An Rs 232 Interface; General - Fronius IG-TL Serie Manual De Instrucciones

Getting started - up to 100 inverters via an RS 232 In-
terface

General

The following steps must be carried out in order to be able to use the interface protocol:
1.
2.
3.
4.
5.
Setting the
inverter number
Assign a separate inverter number to each inverter
Connect inverter, datalogger card / box and interface card / box via a patch cable
Connect the interface card / box to a 3rd party device (PC, converter, etc.) using an
RS 232 interface cable
Insert 2 terminating plugs in the last free 'IN' and 'OUT' socket
Set the baud rate
(1)
1. Switch to the menu level (press the
'Menu' key)
2. Select the 'Setup' mode (1) using the
'Left' or 'Right' keys
3. Press the 'Enter' key
- 'Stand
4. Select the 'IG-NR' menu item using
the 'Up' and 'Down' keys
5. Press the 'Enter' key
- The inverter number is shown;
the first digit flashes
6. Use the 'Up' and 'Down' keys to
select a value for the first digit
7. Press the 'Enter' key
21
' is displayed
by