Selecting The Interface Protocol - Fronius IG-TL Serie Manual De Instrucciones

Selecting the
interface protocol
(1)
14
1. Switch to the menu level (press the
'Menu' key)
2. Select the 'Setup' (1) mode using the
'Left' or 'Right' keys
3. Press the 'Enter' key
- 'Stand ' is displayed
by
4. Immediately press the 'Menu' key five
times
- '00000 ' is displayed
CODE
5. Use the 'Up' and 'Down' keys to
change the flashing number
6. Confirm the number using the 'Enter'
key
7. Enter code 22742
8. After entering all numbers, press the
'Enter' key
- Display flashes
9. Press the 'Enter' key again
- 'MIX ' is displayed
Mode
Important 'DC ' is displayed for inver-
Mode
ters with only one power module.
10. Use the 'Up' and 'Down' keys to select
'COMM'
11. Confirm using the 'Enter' key
- 'MODE' is displayed
12. Confirm using the 'Enter' key