Nilfisk Liberty SC50 Instrucciones De Uso página 35

RECORDING FOR AUTONOMOUS MODE - CONTINUED
RECORDING COPYCAT™ PLANS
When finished CopyCat recording, press the Stop Switch (T) or Record Switch (U),
4
to stop recording. Pressing either button brings up a menu with the options to save
or cancel the plan.
a. Use the up and down navigation arrows (Y1) to choose between;
• " ü " (X39) to Save the plan
• " X " (X31) to cancel the plan
b. Press the right arrow to select the option
c. Or press left arrow to exit and continue recording
5 While computer is compiling/saving the plan.
a. Display will show Computer Processing Indicator (X30) and Autonomous
Indicator (X25).
b. LED Status Bar will be blue with bouncing black bar.
c. Do not move machine while plan is being saved.
d. This may take several minutes.
6 Machine indicates if recording was successful or failed.
a. If plan saves successfully the screen will display;
i. Autonomous Indicator (X25), Battery Charge Indicator (X3) and Machine
On a Plan Indicator (X32) (if the plan has different start and end points).
Note: (X32) is shown because the machine is now located on a saved
plan.
ii. Autonomous Indicator (X25) and Playback Available Indicator (X29)
(if the plan has the same start and end point). Note: (X29) is shown
because the machine is now located within the start area of a saved plan.
iii. Machine will emit 3 ascending tones. Note: If (X29) is shown then the
machine will emit an additional 2 beeps to indicate that it is within the
start area of a saved plan.
b. If plan fails to save the screen will display a fault code.
7 Machine LED Status Bar will change from green to OFF.
2/2019
INSTRUCTIONS FOR USE
X25
X25
X25
56091204 - Nilfisk Liberty SC50
ENGLISH - A
X39
X31
X30
X3 X32
X29
A - 35