Autonomous Help Screen (Actions/Commands) - Nilfisk Liberty SC50 Instrucciones De Uso

A - ENGLISH

AUTONOMOUS HELP SCREEN (ACTIONS/COMMANDS)

Pressing the Autonomous Help Screen Switch (S) will bring up a help screen of information and/or actions
the operator can take at that particular point in time (screen will vary depending upon what the machine
is currently doing, where it's located and what is allowed). Use the four Navigation Arrows (Y1) (up,
down, left & right) to move through the screen and the information switch to exit the screen. The table
below shows actions that can be taken directly from the screen, the table on the previous page shows
informational messages.
Machine State
No location tag set or
machine needs to see a
location tag
Machine is located on a
recorded plan, but not
within the start area of
that plan
Machine is not located on
a recorded plan
*Tag: 0 . . moving "0" indicates that machine is actively scanning for a location tag.
**Tag: "x" where "x" is the location tag ID number.
A - 20
INSTRUCTIONS FOR USE
Appears on Display
(X27)
(X25) &
(X32)
Manual Mode Display
Nilfisk Liberty SC50 - 56091204
Autonomous Help Screen
Need to set Location tag
Set new Location tag
Delete next seen tag
Back Select Tag:0 . . *
l
On plan: make new plan
Delete this plan
Back Select
l
Not on plan: make plan
Set new Location tag
Delete current tag #4**
Delete next seen tag
Change Location tag
Back Select Tag:4**
S
2/2019