Nilfisk Liberty SC50 Instrucciones De Uso página 41

PLAYBACK OF RECORDED PLAN, AUTONOMOUS MODE - CONTINUED
CONTROL PANEL INPUTS WHILE IN PLAYBACK MODE
• If the Stop Switch (T) is pressed the machine will stop and go into manual mode.
• If the Pause Switch (V) is pressed the machine will pause playback. Place the SmartKey back on the reader and press Pause Switch (V)
again, then remove SmartKey to resume playback.
• If the Emergency Stop (D) is pressed the machine will stop immediately and go into manual mode.
• The Power Switch (B) and Horn (C) will function the same as in manual mode.
• All other switches (and speed control knob) are "locked out" pressing them will have no effect.
While in Playback Mode...
Operator needs to interrupt autonomy to Take-Over Cleaning
1 The operator can simply step onto the machine while the machine is cleaning in autonomous mode.
2 Machine stops/pauses project – lifts scrub deck, stops solution/detergent flow, travels a bit further to vacuum water, lifts squeegee/stops vac.
3 Operator inserts SmartKey.
4 Machine signals that operator now has control of machine by lighting Manual Operation Indicator (H).
5 Operator can now drive/operate machine as needed in manual mode.
Playback needs to be paused/resumed
1 If autonomous scrubbing needs to be interrupted during the playback of a plan (to re-fill solution tank,
empty recovery tank etc.) press the Play/Pause Switch (V) to stop machine movement and stop all
functions. The machine will remember where it left off playback and create a temporary "resume area".
Note this location with a flag or marker to easily return here and resume playback.
2 Go empty recovery tank, refill solution etc.
3 After returning to where the recording was paused, the machine will beep twice and display Resume Plan
Available Indicator (X33) as it enters the "resume area". Press the Play Switch (V) to resume and finish
cleaning the plan.
FIGURE 3-9
D
H
2/2019
INSTRUCTIONS FOR USE
CB1 CB2
K1
5A 5A
V
T
56091204 - Nilfisk Liberty SC50
X33
CB3
15A
ENGLISH - A
A - 41