Maintenance; Maintenance Schedule; Cleaning Recovery Tank - Nilfisk Liberty SC50 Instrucciones De Uso

MAINTENANCE

MAINTENANCE SCHEDULE

Remove any debris attached to the rear wheels
Clean Squeegee's Front Roller Wheels (10) verify they rotate freely
Check/Clean Vacuum Motor Fan Inlet Screen (28)
Empty/Clean Debris Catch Tray (23) in Recovery Tank
Clean 3-D Vision Sensor lenses see "CLEAN SENSOR LENSES"
Clean Drop-Off Sensors (4) lenses see "CLEAN SENSOR LENSES"
Clean 2D Mapping Sensor lens see "CLEAN SENSOR LENSES"
* Have an Authorized Nilfisk Service Center check the vacuum motor carbon motor brushes after 1200 operating hours (replace motor after 2000
recovery hours).
NOTE: Refer to the Service Manual for more detail on maintenance and service repairs.

CLEANING RECOVERY TANK

1 Drive the machine to the appointed disposal area.
2 Ensure that the machine is off and the Magnetic
SmartKey (Z) is removed.
See Figure 4-1. Pull the Recovery Tank Drain Hose (37)
3
from its storage area.
4 Direct the hose to a designated "DISPOSAL SITE" and
unscrew the cap (hold the end of the hose above the
water level in the tank to avoid sudden, uncontrolled flow
of waste water). The Recovery Tank Drain Hose can be
squeezed to regulate the flow.
Unlatch (36) and lift open the Recovery Tank Cover (20)
5
set the prop rod (39).
6 Rinse the recovery tank out thoroughly to remove any
and all debris from the tank. To clean out the recovery
tank leave the drain hose open to a floor drain and spray
the inside of the tank clean with a hose. A hose with a
spray attachment can be used to spray out the recovery
tank but should not be directed to the vacuum motor inlet
at the center of the tank. Do not allow sprayed water to
splash outside of tank or into the vacuum motor inlet.
NOTE: The spray hose should not be used to clean the
exterior of the machine near the operator control panel
and sensors to prevent water ingress into sensitive
electronics.
7 Remove the Debris Catch Tray (23) from the recovery
tank. Empty and rinse the debris catch tray then reinstall it.
8 Remove any debris that has gathered on the recovery vacuum inlet screen (28). Remove the screen and rinse then reinstall.
Check the condition of the tank cover gasket (47) and the area it seats against. They should be clean to create a good seal.
9
NOTE: The Gasket (47) allows the creation of a vacuum in the tank, which is necessary to suck up the recovery water.
10 Close and latch the recovery tank cover.
2/2019
MAINTENANCE ITEM
Charge Batteries
Check/Clean Tanks & Hoses
Check/Clean the Brushes/Pads
Check/Clean the Squeegee
Inspect Scrub Housing Skirt
Inspect and clean Solution Filter (33)
Purge Detergent System
Lubrication of Machine
* Check Carbon Brushes
INSTRUCTIONS FOR USE
Daily Weekly
X
X
X
X
X
X
X
X
X
X
X
39
22
56091204 - Nilfisk Liberty SC50
ENGLISH - A
As needed
Monthly Yearly
only
X
X
FIGURE 4-1
20
28
X
X
X
23
47
36
37
A - 47