Run / Stop The Trigger; Horizontal Scale And Position; Horizontal Position - Promax OD-405 Manual De Instrucciones

5.1.3 Run / Stop the trigger

In the trigger Run mode the oscilloscope constantly searchers for a
trigger condition an updates the signal into the display when the condition is
met.
In the trigger Stop mode, the oscilloscope stops triggering and these the
lass acquired waveforms stay in the display. The trigger icon at the top of the
display changes into Stop mode.
Pressing the Trigger Run / Stop key switches between the Run and
Stop mode.
Waveform
Operation

5.1.4 Horizontal scale and position

5.1.4.1

Horizontal Position

The horizontal position knob [9] moves the waveform left or right. The
position indicator moves along the waveform and the distance from the center
point is displayed as the offset in the upper side of the display.
11-2011
Figure 7.-
Waveforms can be moved or scaled in both the Run and
Stop mode.
USER'S MANUAL. OD-405/410B/411/415
Page 36