Using The Probe Compensation Signal - Promax OD-405 Manual De Instrucciones

5.1.6 Using the probe compensation signal.

This section introduces how to use the probe compensation signal for
general usage, in case the DUT signal is not available or to get a second
signal for comparison.
Note : The frequency accuracy and duty factor are not guaranteed.
Therefore the signal should not be used for reference purposes.
1. Connect the probe between the compensation signal output and
channel input [18].
2. Press the Utility key.
3. Press ProbeComp.
4. Press Wave type repeatedly to select the wave type.
11-2011
Square waveform used for probe compensation.
1k ~ 100kHz, 5% ~ 95%.
Demonstration signal for showing the effects of peak
detection.
Figure 10.-
USER'S MANUAL. OD-405/410B/411/415
Page 38