Recalling Panel Settings; Recalling A Waveform - Promax OD-405 Manual De Instrucciones

USER'S MANUAL. OD-405/410B/411/415
4. Press Ref.A (F2) or Ref.B (F3) to activate (ON) / off (OFF) displaying
the waveform of reference. When the waveform reference is active,
shown in the same menu scale vertical and horizontal when it had
been saved.

5.12.3 Recalling panel settings

The scopes of the series OD-400 configurations allow load acquisition
previously stored in internal memory or USB memory. This allows not having
to go shaping the team ever when it comes to repetitive work.
Procedure
1. Press Save / Recall repeatedly until you see the menu RECALL.
2. Press the function key F2.
3. Press Source (F2) repeatedly to select the file source, internal or
external memory. Use the Variable Knob to change the memory.
4. Turn the variable knob to select one of the internal memories
S15) or one of the files stored on the USB memory. In the latter case,
pressing Utilities Files (F5) can directly access the folder and the file
desired.
5. Press Recall (F4) to confirm recalling. When it is completed a
message appears at the bottom of the display.

5.12.4 Recalling a waveform

The OD-400 series allow waveforms to be recalled from internal memory
(W1~W15) or from external memory (USB) to one or two reference waveforms
(REF A, REF B).
Procedure
1. The waveform must be stored previously.
2. Press Save / Recall repeatedly until you see the menu RECALL.
Page 91
(S1 ~
11-2011