Run Go-Nogo Tests - Promax OD-405 Manual De Instrucciones

USER'S MANUAL. OD-405/410B/411/415

5.4.2 Run Go-NoGo Tests

Procedure
1. Press the Utility key.
2. Press the More key.
3. Press the Go-NoGo Menu key.
Ensure the source signal and boundary templates appear on the
screen.
4. Press Go-NoGo. The test starts and stops according to the
conditions set. To stop the test that has already started, press
Go-NoGo again.
5. The test results appear in the Ratio soft-key. The numerator denotes
the total number of failed tests. The denominator denotes the total
number of tests.
Numerator
Denominator
Page 53
Auto template
Tolerance
Source waveform
Figure 15.-
Number of "failed" tests.
Total number of tests.
11-2011