Horizontal Adjustment Menu (Od-411/Od-415); Vertical View (Channel); Moving The Waveform Position Vertically; Selecting The Vertical Scale - Promax OD-405 Manual De Instrucciones

5.6.5 Horizontal Adjustment Menu (OD-411/OD-415)

For the OD-411/OD-415, the horizontal adjustment menu allows markers
to be set at different times relative to the Horizontal position marker at 0
seconds. Each marker is linked to the mark directly before and after (in time).
There can be up to 30 markers linked together.
1. Press the Horizontal menu key twice to enter the horizontal
adjustment menu
2. Press H Pos Adj to toggle between coarse and fine adjustments.
3. Adjust the horizontal position with the horizontal position knob.
4. Press Set/Clear to create a marker at the current horizontal position.
5. If there is already a marker at the current horizontal position press
Set/Clear to delete the current marker.
6. Press Reset to reset the horizontal position to 0 seconds when the
trigger is running, or to the last position before the trigger was
stopped.
7. Press Previous to go to the previous marker.
8. Press Next to go to the next marker.

5.6.6 Vertical View (Channel)

The vertical view section describes how to set the vertical scale,
position, bandwidth limitation, coupling mode and attenuation.
5.6.6.1

Moving the waveform position vertically

To move the waveform up or down, turn the vertical position knob for
each channel.
5.6.6.2

Selecting the vertical scale

To change the vertical scale, turn the VOLTS/DIV knob; left (down) or
right (up).
Range: 2mV/Div — 5V/Div, 1-2-5 increments.
11-2011
USER'S MANUAL. OD-405/410B/411/415
Page 64