MG TF 2008 Manual De Servicio página 197

SENSOR - INTAKE AIR TEMPERATURE (IAT)
$% 18.30.09
Remove
1. Remove engine compartment access panel. 1. Remove engine compartment access panel.
+
ENGINE COMPARTMENT ACCESS PANEL,
page 76-2-4.
2. Disconnect IAT sensor multiplug. 2. Disconnect IAT sensor multiplug.
3. Loosen and remove IAT sensor. 3. Loosen and remove IAT sensor.
Refit
1. Fit and tighten IAT sensor. 1. Fit and tighten IAT sensor.
2. Connect IAT sensor multiplug. 2. Connect IAT sensor multiplug.
3. Fit engine compartment access panel. 3. Fit engine compartment access panel.
+
ENGINE COMPARTMENT ACCESS PANEL,
page 76-2-4.
ENGINE MANAGEMENT SYSTEM - MEMS
SENSOR - MANIFOLD ABSOLUTE
PRESSURE (MAP)
$% 18.30.56
Remove
1. Disconnect battery earth lead. 1. Disconnect battery earth lead.
2. Remove engine compartment access cover. 2. Remove engine compartment access cover.
+
ENGINE COMPARTMENT ACCESS PANEL,
page 76-2-4.
3. Disconnect MAP sensor multiplug. 3. Disconnect MAP sensor multiplug.
4. Remove 2 Torx screws securing MAP sensor to inlet 4. Remove 2 Torx screws securing MAP sensor to inlet
manifold.
5. Remove MAP sensor from manifold. 5. Remove MAP sensor from manifold.
Refit
1. Clean MAP sensor and manifold mating faces. 1. Clean MAP sensor and manifold mating faces.
2. Ensure 2 'O' rings are fitted to sensor. 2. Ensure 2 'O' rings are fitted to sensor.
3. Fit sensor to manifold and tighten Torx screws to 3 3. Fit sensor to manifold and tighten Torx screws to 3
Nm.
4. Connect multiplug to MAP sensor. 4. Connect multiplug to MAP sensor.
5. Fit engine compartment access cover. 5. Fit engine compartment access cover.
+
ENGINE COMPARTMENT ACCESS PANEL,
page 76-2-4.
6. Connect battery earth lead. 6. Connect battery earth lead.
18-19
REPAIRS