Tabla de contenido
Publicidad
HEATING & VENTILATION
4. Disconnect multiplug from heater blower.
4. Disconnect multiplug from heater blower.
5. Remove 3 screws securing blower to heater.
5. Remove 3 screws securing blower to heater.
6. Remove heater blower.
6. Remove heater blower.
7. Release armature cover and collect sleeve.
7. Release armature cover and collect sleeve.
Refit
1. Position screw and sleeve to top location of heater
1. Position screw and sleeve to top location of heater
blower.
2. Position blower to heater and secure with screws.
2. Position blower to heater and secure with screws.
CAUTION: Ensure screw sleeve does not fall into blower
motor.
3. Connect multiplug to blower.
3. Connect multiplug to blower.
4. Fit heater duct.
4. Fit heater duct.
5. Position throttle pedal assembly, fit and tighten nuts
5. Position throttle pedal assembly, fit and tighten nuts
to 6 Nm.
6. Fit and tighten bolt to 22 Nm.
6. Fit and tighten bolt to 22 Nm.
80-16
REPAIRS
HEATER RESISTOR
$% 80.20.17
Remove
1. Remove bolt securing throttle pedal bracket to pedal
1. Remove bolt securing throttle pedal bracket to pedal
box.
2. Remove 2 nuts securing throttle pedal bracket to
2. Remove 2 nuts securing throttle pedal bracket to
bulkhead and position throttle pedal assembly aside.
Publicidad
Tabla de contenido
