Tabla de contenido
Publicidad
WIPER ARM
$% 84.15.02
Remove
1. Open bonnet.
1. Open bonnet.
2. Remove cover from wiper arm.
2. Remove cover from wiper arm.
3. Remove nut securing wiper arm to spindle.
3. Remove nut securing wiper arm to spindle.
4. Remove wiper arm.
4. Remove wiper arm.
Refit
1. Fit wiper arm to spindle and align blade to screen.
1. Fit wiper arm to spindle and align blade to screen.
2. Fit and tighten nut to 20 Nm.
2. Fit and tighten nut to 20 Nm.
3. Fit cover.
3. Fit cover.
WIPERS & WASHERS
WIPER MOTOR AND LINKAGE
$% 84.15.11
Remove
1. Remove air intake panel.
1. Remove air intake panel.
+
AIR INTAKE PANEL, page 80-8.
2. Remove underbonnet closing panel.
2. Remove underbonnet closing panel.
+
UNDERBONNET CLOSING PANEL, page 76-2-3.
3. Disconnect multiplug from motor.
3. Disconnect multiplug from motor.
4. Remove cover from spindle.
4. Remove cover from spindle.
5. Remove 2 nuts securing spindles to scuttle.
5. Remove 2 nuts securing spindles to scuttle.
6. Remove bolt securing motor to pedal box.
6. Remove bolt securing motor to pedal box.
7. Remove motor and linkage assembly.
7. Remove motor and linkage assembly.
Refit
1. Position motor and linkage assembly to scuttle.
1. Position motor and linkage assembly to scuttle.
NOTE: Ensure spindle seals are correctly positioned to scuttle
apertures.
2. Tighten fixings to 10 Nm.
2. Tighten fixings to 10 Nm.
3. Fit spindle cover.
3. Fit spindle cover.
4. Connect multiplug.
4. Connect multiplug.
5. Fit air intake panel.
5. Fit air intake panel.
+
AIR INTAKE PANEL, page 80-8.
6. Fit underbonnet closing panel.
6. Fit underbonnet closing panel.
+
UNDERBONNET CLOSING PANEL, page 76-2-3.
84-3
REPAIRS
Publicidad
Tabla de contenido
