MG TF 2008 Manual De Servicio página 481

ENGINE HARNESS
$% 86.70.17
Remove
1. Battery - negative/positive leads. 1. Battery - negative/positive leads.
2. Cover - engine compartment. 2. Cover - engine compartment.
+
ENGINE COVER, page 12-27.
3. Grille - engine compartment. 3. Grille - engine compartment.
4. Bolts x 2 - ECM bracket - 8 Nm - multiplugs x 2 - 4. Bolts x 2 - ECM bracket - 8 Nm - multiplugs x 2 -
harness clip.
5. Multiplugs x 2 - main harness to engine harness. 5. Multiplugs x 2 - main harness to engine harness.
6. ECM assembly. 6. ECM assembly.
7. Bolt - earth leads to body. 7. Bolt - earth leads to body.
8. Lucar connector - starter motor solenoid. 8. Lucar connector - starter motor solenoid.
9. Terminal nut - starter motor solenoid - 13 Nm. 9. Terminal nut - starter motor solenoid - 13 Nm.
10. Connectors x 2 - reverse lamp switch. 10. Connectors x 2 - reverse lamp switch.
11. Multiplugs x 2 - HO2S - post and pre-catalyst. 11. Multiplugs x 2 - HO2S - post and pre-catalyst.
12. Multiplugs x 2 - ECT and temperature gauge sensors. 12. Multiplugs x 2 - ECT and temperature gauge sensors.
13. Bolts x 3 - coil cover 8 Nm. 13. Bolts x 3 - coil cover 8 Nm.
14. Multiplugs x 4 14. Multiplugs x 4
Ignition coils Ignition coils
l l
CMP sensor CMP sensor
l l
MAP sensor MAP sensor
l l
15. Multiplugs x 3 - (VVC) 15. Multiplugs x 3 - (VVC)
HCU solenoids HCU solenoids
l l
Oil temperature sensor Oil temperature sensor
l l
16. Multiplug - CKP sensor. 16. Multiplug - CKP sensor.
17. Multiplug - injector harness. 17. Multiplug - injector harness.
ELECTRICAL
18. Raise front of vehicle one side and support on stand. 18. Raise front of vehicle one side and support on stand.
19. Remove RH rear road wheel. 19. Remove RH rear road wheel.
20. Scrivets x 2 - Torx screw - RH closing panel. 20. Scrivets x 2 - Torx screw - RH closing panel.
21. Clips x 3 - armour to harness. 21. Clips x 3 - armour to harness.
22. Multiplug - Nut - alternator connections. 22. Multiplug - Nut - alternator connections.
23. Multiplugs x 3 23. Multiplugs x 3
A/C compressor A/C compressor
l l
Oil temperature sensor Oil temperature sensor
l l
Oil pressure sensor Oil pressure sensor
l l
24. Harness - release - engine front. 24. Harness - release - engine front.
25. Clips x 4 - harness to coolant rail and throttle body. 25. Clips x 4 - harness to coolant rail and throttle body.
26. Harness - manoeuvre and remove. 26. Harness - manoeuvre and remove.
27. Clips x 3 - armour to new harness. 27. Clips x 3 - armour to new harness.
28. Armour - remove from new harness. 28. Armour - remove from new harness.
29. Align armour to engine harness - clips x 3. 29. Align armour to engine harness - clips x 3.
86-29
REPAIRS