Tabla de contenido
Publicidad
3. Disconnect multiplug from resistor.
3. Disconnect multiplug from resistor.
4. Remove 2 screws securing resistor.
4. Remove 2 screws securing resistor.
5. Remove heater resistor.
5. Remove heater resistor.
Refit
1. Position resistor to heater and secure with screws.
1. Position resistor to heater and secure with screws.
2. Connect resistor multiplug.
2. Connect resistor multiplug.
3. Position throttle pedal assembly, fit and tighten nuts
3. Position throttle pedal assembly, fit and tighten nuts
to 6 Nm.
4. Fit and tighten bolt to 22 Nm.
4. Fit and tighten bolt to 22 Nm.
HEATING & VENTILATION
HEATER MATRIX
$% 80.20.29
Remove
1. Remove heater.
1. Remove heater.
+
HEATER, page 80-9.
2. Disconnect multiplugs from blower and resistor.
2. Disconnect multiplugs from blower and resistor.
3. Release harness from 2 clips and position aside.
3. Release harness from 2 clips and position aside.
80-17
REPAIRS
Publicidad
Tabla de contenido
