Tabla de contenido
Publicidad
Refit
1. Route auto changer cable behind console closing
1. Route auto changer cable behind console closing
panel and into audio unit aperture.
2. Route auto changer data cable under sound
2. Route auto changer data cable under sound
deadening and carpet in LH footwell and along harness.
Secure with cable ties.
3. Route auto changer data cable under roof hinge and
3. Route auto changer data cable under roof hinge and
into hood compartment. Secure with cable ties.
4. Replace sound deadening and secure carpet with
4. Replace sound deadening and secure carpet with
trim clips.
5. Position centre console closing panel, connect Lucar
5. Position centre console closing panel, connect Lucar
connectors and secure closing panel with screws.
6. Fit lower section of LH door seal to secure carpet.
6. Fit lower section of LH door seal to secure carpet.
7. Fit new grommet to auto changer data cable. Feed
7. Fit new grommet to auto changer data cable. Feed
data cable through aperture and fit new grommet to body.
8. Feed auto changer data cable along cavity and into
8. Feed auto changer data cable along cavity and into
luggage compartment. Secure with supplied cable tie clip and
attach to body to prevent damage to cable.
9. Secure auto changer data cable to harness with cable
9. Secure auto changer data cable to harness with cable
ties and feed through luggage compartment trim.
10. Position luggage compartment trim.
10. Position luggage compartment trim.
11. Feed auto changer data cable through slit in luggage
11. Feed auto changer data cable through slit in luggage
compartment trim.
12. Refit luggage compartment trim.
12. Refit luggage compartment trim.
+
LUGGAGE COMPARTMENT TRIM, page 76-4-2.
ELECTRICAL
13. Attach brackets to auto changer with 4 screws and
13. Attach brackets to auto changer with 4 screws and
secure to vehicle with 4 bolts. Tighten bolts to 5 Nm.
14. Connect auto changer multiplug to auto changer.
14. Connect auto changer multiplug to auto changer.
15. Lower rear of hood and engage clips to secure rear
15. Lower rear of hood and engage clips to secure rear
of hood to body.
16. Engage hoodwell carpet beneath flip seal.
16. Engage hoodwell carpet beneath flip seal.
17. Position rear window and zip up top edge.
17. Position rear window and zip up top edge.
18. Secure catches to secure front of hood.
18. Secure catches to secure front of hood.
19. Fit head unit.
19. Fit head unit.
+
HEAD UNIT - AUDIO SYSTEMS, page 86-15.
20. Connect battery earth lead.
20. Connect battery earth lead.
21. Raise windows.
21. Raise windows.
22. Check audio unit including CD auto changer for
22. Check audio unit including CD auto changer for
correct operation and program suitable radio stations on
all pre-sets.
86-17
REPAIRS
Publicidad
Tabla de contenido
