MG TF 2008 Manual De Servicio página 464

ELECTRICAL
FRONT SPEAKER
$% 86.50.15
Remove
1. Remove front door trim casing. 1. Remove front door trim casing.
+
TRIM CASING, page 76-1-6.
2. Remove 3 screws securing speaker to door. 2. Remove 3 screws securing speaker to door.
3. Release speaker from door, disconnect 2 Lucars. 3. Release speaker from door, disconnect 2 Lucars.
4. Remove speaker. 4. Remove speaker.
Refit
1. Position speaker to door and connect Lucars. 1. Position speaker to door and connect Lucars.
2. Align speaker to door and secure with screws. 2. Align speaker to door and secure with screws.
3. Fit front door trim casing. 3. Fit front door trim casing.
+
TRIM CASING, page 76-1-6.
86-12
REPAIRS
AERIAL
$% 86.50.18
Remove
1. Remove engine compartment access grille. 1. Remove engine compartment access grille.
+
ENGINE COMPARTMENT ACCESS PANEL,
page 76-2-4.
2. Unscrew aerial from base. 2. Unscrew aerial from base.
3. Using a 17 mm open ended spanner, remove aerial 3. Using a 17 mm open ended spanner, remove aerial
base locking nut.
4. Collect locking nut and outer sleeve. 4. Collect locking nut and outer sleeve.
5. Remove aerial base from body. 5. Remove aerial base from body.
6. Disconnect aerial coaxial lead from harness. 6. Disconnect aerial coaxial lead from harness.
Refit
1. Position aerial base in body. 1. Position aerial base in body.
2. Fit sleeve and tighten locking nut to 3 Nm. 2. Fit sleeve and tighten locking nut to 3 Nm.
NOTE: If the vehicle is fitted with a rear spoiler ensure the
aerial mast does not contact the rear spoiler before tightening
the locking nut.
3. Connect aerial coaxial lead to harness. 3. Connect aerial coaxial lead to harness.
4. Screw aerial into base. 4. Screw aerial into base.
5. Fit engine compartment access grille. 5. Fit engine compartment access grille.
+
ENGINE COMPARTMENT ACCESS PANEL,
page 76-2-4.