Scanning With The Universal Plate - Amann Girrbach 179560 Modo De Empleo

A P P L I C A T I O N T I P S
After inserting a model into the scanner:
▷ Check the height of the line (single or double
E N
line) at which the denture is located.
Fig. 12 High model (single line)
Fig. 13 Low model (double line)
▷ In the software, select the line at which the
height of the denture is located.
1 2
Fig. 14
1 Button for single line (high model)
2 Button for double line (low model)
The scanner now automatically aligns the model
to the required height in the measuring field.
▷ Start the scan procedure.
38
6.2

Scanning with the universal plate

2
Fig. 15 Model fixation
1 Universal plate (delivery scope)
2 Modelling wax
3 Fixation pin incl. fixation spring lever
4 Splitex retainer
The Splitex retainer is in the desktop scanner. The
universal plate or alternatively models with Spli-
tex counter plate are placed on it, depending on
requirement.
3
1
4