Safety; General Information And Notes For The Reader; Intended Use; General Information - ABB Sensyflow FMT500-IG Instrucciónes De Puesta En Marcha

Safety

1 Safety
1.1

General information and notes for the reader

You must read these instructions carefully prior to installing and commissioning the device.
These instructions are an important part of the product and must be kept for future reference.
These instructions are intended as an overview and do not contain detailed information on all
designs for this product or every possible aspect of installation, operation and maintenance.
For additional information or if specific problems occur that are not discussed in these
instructions, contact the manufacturer.
The content of these instructions is neither part of any previous or existing agreement, promise
or legal relationship nor is it intended to change the same.
This product is built based on state-of-the-art technology and is operationally safe. It has been
tested and left the factory in perfect working order from a safety perspective. The information in
the manual must be observed and followed in order to maintain this state throughout the period
of operation.
Modifications and repairs to the product may only be performed if expressly permitted by these
instructions.
Only by observing all of the safety instructions and all safety/warning symbols in these
instructions can optimum protection of both personnel and the environment, as well as safe and
fault-free operation of the device, be ensured.
Information and symbols directly on the product must be observed. They may not be removed
and must be fully legible at all times.
1.2

Intended use

Mass flow measurement of gases and gas mixtures in closed pipelines.
The device is designed for use exclusively within the stated values on the name plate and in the
technical specifications.
1.2.1

General information

• The device (including the pipe components) has been designed, produced and approved in
accordance with Pressure Equipment Directive 97/23/EC. The pipe components take the
form of a
-
-
-
The device may only be used in accordance with the application specified on the order
confirmation; other operating conditions may prevent the device from functioning correctly,
cause damage to it or even damage it beyond repair.
• Care must be taken to ensure that the measuring media used do not impair the chemical and
physical properties of the components that come into contact with the fluids concerned.
• The threshold value for alternating load cycles corresponds to AD-2000 instruction sheet S1,
Section 1.4 and is not calculated or checked by the manufacturer.
• The device should be included in any regular maintenance activities that are carried out on
the entire system.
4 - EN
Wafer design
Flange design with integrated measuring section
Weld-on adapter
Sensyflow FMT500-IG CI/FMT500-IG-X1