Parameter Changes - ABB Sensyflow FMT500-IG Instrucciónes De Puesta En Marcha

HART parameterization
9.1.2

Parameter changes

To save parameter changes, you need to perform 3 separate operations:
1. Enter password (OPERATION MODE)
2. Make changes to parameters in the menus
3. Save
Changing text and values
The process will be illustrated on the basis of the TAG NO. This input mask can be found in the
PARAMETER MENU and can be accessed from any display mode using
Entries and changes can only be made in the SPECIALIST or SERVICE operation modes (see
Section 9.1.1, "Operation modes").
NITROGEN
►
PARAMETER MENU
►
TAG NO LONG
►
SENSYFLOW-IG 123
TAG NO LONG
►
SENSYFLOW-IG 123
42 - EN
T: 27 °C
5,
+
< >
Sensyflow FMT500-IG
Press 3 times.
kg/h
942
Press.
Press.
Press.
Press.
Press.
To make the entry, use
and (to set the numerical value or required
character). To complete the entry process, the
cursor must be moved to the right of the input field
(16 characters in the example). Only when the
cursor is in this position will
to
exit change mode by pressing
The display will revert to the PARAMETER MENU,
where you can make additional configuration
changes.
, (cursor position)
+
on the display, making it possible to
.
CI/FMT500-IG-X1
and .
change back