Parameter Changes - ABB Sensyflow FMT500-IG Instrucciónes De Puesta En Marcha

PROFIBUS DPV1 parameterization

10.1.2 Parameter changes

To save parameter changes, you need to perform 3 separate operations:
1. Enter password (OPERATION MODE)
2. Make changes to parameters in the menus
3. Save
Changing text and values
The process will be illustrated on the basis of the PROFIBUS SLAVE ADDRESS. This input
mask can be found in the PARAMETER MENU and can be accessed from any display mode
using
operation modes (see Section 10.1.1, "Operation modes").
NITROGEN
►
PARAMETER MENU
►
DP SLAVE ADRESS
►
015
DP SLAVE ADRESS
►
015
46 - EN
and . Entries and changes can only be made in the SPECIALIST or SERVICE
T: 27 °C
5,
+
< >
Sensyflow FMT500-IG
Press 6 times.
kg/h
942
Press.
Press 3 times.
Press.
Press.
Press.
To make the entry, use
and (to set the numerical value or required
character). To complete the entry process, the
cursor must be moved to the right of the input field
(16 characters in the example). Only when the
cursor is in this position will
to
exit change mode by pressing
The display will revert to the PARAMETER MENU,
where you can make additional configuration
changes.
, (cursor position)
+
on the display, making it possible to
.
CI/FMT500-IG-X1
change back