Disposal; Information On Weee Directive 2002/96/Ec (Waste Electrical And Electronic Equipment); Rohs Directive 2002/95/Ec; Use In Potentially Explosive Atmospheres - ABB Sensyflow FMT500-IG Instrucciónes De Puesta En Marcha

1.9

Disposal

This product is manufactured from materials that can be reused by specialist recycling
companies.
1.9.1

Information on WEEE Directive 2002/96/EC (Waste Electrical and Electronic Equipment)

This product is not subject to WEEE Directive 2002/96/EC or relevant national laws
(e.g., ElektroG in Germany).
The product must be disposed of at a specialist recycling facility. Do not use municipal garbage
collection points. According to the WEEE Directive 2002/96/EC, only products used in private
applications may be disposed of at municipal garbage facilities. Proper disposal prevents
negative effects on people and the environment, and supports the reuse of valuable raw
materials.
If it is not possible to dispose of old equipment properly, ABB Service can accept and dispose of
returns for a fee.
1.9.2

RoHS Directive 2002/95/EC

With the Electrical and Electronic Equipment Act (ElektroG) in Germany, the European
Directives 2002/96/EC (WEEE) and 2002/95/EC (RoHS) are translated into national law.
ElektroG defines the products that are subject to regulated collection and disposal or reuse in
the event of disposal or at the end of their service life. ElektroG also prohibits the marketing of
electrical and electronic equipment that contains certain amounts of lead, cadmium, mercury,
hexavalent chromium, polybrominated biphenyls (PBB), and polybrominated diphenyl ethers
(PBDE) (also known as hazardous substances with restricted uses).
The products provided by ABB Automation Products GmbH do not fall within the current scope
of the directive on waste from electrical and electronic equipment according to ElektroG. If the
necessary components are available on the market at the right time, in the future these
substances will no longer be used in new product development.
2

Use in potentially explosive atmospheres

Special regulations must be observed in potentially explosive atmospheres as regards the
power supply, signal input / output and ground connections.
All parts must be installed in accordance with the manufacturer's specifications, as well as
relevant standards and regulations.
Commissioning and operation must comply with EN 60079-14 (Installation of equipment in
potentially explosive atmospheres).
2.1

Approvals

Data relating to the approvals for use in potentially explosive atmospheres can be found in the
section titled "Ex relevant specifications".
2.2

Ex relevant specifications

See the section titled "Ex relevant specifications", page 48.
CI/FMT500-IG-X1
Use in potentially explosive atmospheres
Sensyflow FMT500-IG EN - 11