Troubleshooting - GreenWorks Tools 25157 Manual De Utilización

EN
FR DE DE ES IT PT
FR EN ES IT PT
Deutsch (Übersetzung der originalen Anleitungen)

TROUBLESHOOTING

Problem
Handle is not in position.
Mower is not starting.
Mower is cutting grass unevenly.
Mower is not mulching properly.
Mower is hard to push.
Mower is not bagging properly.
Mower is vibrating at higher speed.
Motor stops while cutting.
If these solutions do not solve the problem contact your authorised service dealer.
NL SV DA NO FI HU CS RU
NL SV DA NO FI HU CS RU
English (Original instructions)
Possible cause
Carriage bolts are
properly.
Cam handle is not tightened.
Battery is low in charge.
Battery is either inoperable or will not
take a charge.
Lawn is rough or uneven or cutting
height not set properly.
Wet grass clippings are sticking to
the underside of the deck.
High grass, rear of mower housing
and blade are dragging in heavy
grass, or cutting height too low.
Cutting height is set too low.
Blade is unbalanced, excessively or
unevenly worn.
Motor shaft is bent.
Cutting height is set too low.
Battery has no power.
19 19
RO PL SL HR ET
RO PL SL HR ET
Solution
Adjust the height of the handle and
not seated
make sure the carriage bolts are
seated properly.
Tighten cam handle.
Charge the battery.
Replace the battery.
Move the wheels to a higher position.
All wheels must be placed in the
same cutting height for the mower to
cut evenly.
Wait until the grass dries before
mowing.
Raise the cutting height.
Raise the cutting height.
Replace the blade.
Stop the motor, remove isolator key
and battery, disconnect the power
source, and inspect for damage.
Have it repaired by an authorised
service center before restarting.
Raise the cutting height.
Charge the battery.
LT LV SK BG
LT LV SK BG