Closed Captions - Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento

Ancillary Data
Teranex processors support closed captions, timecode and video indexing in the ancillary data.

Closed Captions

Command
CC enabled:
CC input line:
CC output line:
CC service2 source:
CC service1 language:
CC service2 language:
Timecode
Command
Timecode mode:
Timecode input line:
Timecode output line:
Timecode drop frame mode:
Timecode source:
Timecode generate value:
Timecode jam sync value:
Timecode start source:
Command Description
Enable Closed Caption processing. True=ON; False=OFF;
(Default = False)
Analog CC input line selection. Range is 20 to 22.
Default = 21
Analog CC output line selection. Range is 20 to 22.
Default = 21
CC Service 2 selection; Values are CC2 (default) or CC3
Service 1 Language selection. Values are:
English (default), French, German, Italian, Spanish
Service 2 Language selection. Values are:
English (default), French, German, Italian, Spanish
Command Description
Select the mode of the timecode generator. Values are:
Off, Input, InputRegen, Generate, JamSync
Set the line on which the input timecode is located. The valid
range of values is format dependent. To set the unit to the
default automatic input detection mode, enter 0.
NTSC: lines 10-20
PAL: lines 6-22
1080 HD: lines 9-20
720 HD: lines 9-25
Set the line on which the output timecode is located. The
valid range of values is format dependent. To set the unit to
the default output line, enter 0.
NTSC: lines 10-20 (Default = 14)
PAL: lines 6-22 (Default = 19)
1080 HD: lines 9-20 (Default = 9)
720 HD: lines 9-25 (Default = 9)
Change the drop frame mode in valid output formats.
Values are: DF, NDF.
This command is only needed for the Teranex 3D.
Values are: VITC, LTC.
Set the start time of the output timecode generator,
expressed as HH:MM:SS:FF
Set the search value for the Jam Sync generator, expressed
as HH:MM:SS:FF
Set the source of the timecode number used by the
generator. Values are: Input, User (where "User" is equivalent
to "Start Value" in the LCD Menu tree).
Developer Information 106 106