Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento página 71

Output Menu
The '3D output' selection determines the output formatting for your 3D image.
‚ Full Frame
Provides full resolution outputs for left and right eyes on SDI outputs A and B
respectively, while simultaneously providing a frame packed signal on the HDMI output.
‚ Side by Side
Enables 'side by side' output encoding. SDI outputs A and B and the HDMI output will
provide identical side by side output signals.
‚ Top / Bottom
Enables top and bottom output encoding. SDI outputs A and B and the HDMI output
will provide identical top/bottom output signals.
‚ Line by Line
Enables 'line by line' output encoding. SDI outputs A and B and the HDMI output will
provide identical line by line output signals.
Full Frame Left Eye
Top/Bottom Encoding
Intensity Menu
The 'intensity' selection will not be available until 2D to 3D has been selected in the '3D mode'
menu. The 'intensity' setting allows you to control the overall amount of the 3D effect.
‚ The range of adjustment is -40 where the image is in front of the screen to +40 where
the image is behind the screen. The default setting is +15. A setting of 0 provides a flat,
2D output image.
3D Mode 3D
Off
Input
Convert Convert
2D to 3D
Output
3D Align
2D to 3D mode must be active
to adjust Intensity and Depth.
Depth Menu
The 'depth' selection will not be available until 2D to 3D has been selected in the
'3D mode' menu.
The 'depth' setting pushes the overall image deeper. This can add to the 3D effect but in most
cases should be left at the default value.
‚ The range of adjustment is -12 to +12. The default setting is 0.
Full Frame Right Eye
Line by Line Encoding
Intensity 3D Mode 3D
Depth Input
+15
Camera
Output
Align
3D Menu>2D to 3D>Intensity
Side by Side
Intensity
Depth
Camera
Align
Teranex Processor Settings 71 71