Blackmagic Design BMD-TERANEXEXP12GDL Teranex Express Manual De Instalación Y Funcionamiento página 36

Adjust Aspect
To customize the aspect ratio size, position and trim settings, use the soft menu
buttons and rotary knob.
Size
The 'size' setting adjusts the horizontal and/or vertical image size.
The range is approximately -50 to +200 percent.
Position
Position allows you to move the input image within the output frame.
The range of adjustment is dependent on the current image size.
Trim
Trim masks the edges of your input image horizontally and/or vertically.
Horizontal
Used for horizontal sizing, positioning and trimming.
Vertical
Used for vertical sizing, positioning and trimming.
Both
Links horizontal and vertical controls together. For example, when changing
the input image size, linking both controls maintains the proper aspect ratio.
Reset All
Press to return all settings to their default values.
Horizontal Size Size
Vertical Position
0
Both Trim
Reset
All
Horizontal>Size
Aspect Fill
To define the color of the bars used in pillarbox and letterbox aspect ratios, adjust the
'luminance', and 'cb' and 'cr' chroma values using the rotary knob.
Zoom/Crop
Zoom/crop is used to mask potential video disturbances that may appear at the top,
bottom, left or right edges of your source image. This is performed by trimming your
conversion slightly. Turning zoom/crop on will instantly zoom the converted image
vertically by 3 lines and horizontally by 3 pixels, then crop the image by the same
amount. Zoom/crop will not effect your adjustable aspect ratio settings.
Adjust
Fill
Aspect
Aspect
Zoom
Crop
Aspect Menu>Aspect Fill
Horizontal Trim Size
Vertical Position
0
Both Trim
Reset
All
Horizontal>Trim
Adjust
Fill
Zoom Crop
Aspect
On
Zoom
Crop
Off
Aspect Menu>Zoom/Crop
Horizontal Position Size
Vertical Position
0
Both Trim
Reset
All
Horizontal>Position
Luma Fill Cb
Cr
64
Reset
All
Aspect Fill>Luma
Teranex Processor Settings 36 36